Drivers door
#4
#6
#7
The warranty/VIN plate has an interesting set of rivets attaching them to the door, and these can actually be removed with a little effort. The inside can be squeezed to release the entire plate without compromising the rivet itself.
I have a small piece of Stainless steel tube that fits over the rivet and squeezes the rivet. With a small tap, they pop right out. Then another small tap and they can be instaled into any door.
This eliminates a bunch of confusion and too much conversation when I get pulled over by the highway patrol, and the nice officer wants to know why the rivets look so new.
I have been delayed an even impounded once to clarify this problem. They thought I was gettin fancy with the VIN numbers. Took a few days to get the problem resolved and get my baby back. Still had to pay towing and storage too.
Talk about feeling violated. My baby had to spend a few nights in a cold and lonely towing yard.
Perhaps this is an isolated incident but now I have learned to use the factory fasteners.
Cant be too careful.
I have a small piece of Stainless steel tube that fits over the rivet and squeezes the rivet. With a small tap, they pop right out. Then another small tap and they can be instaled into any door.
This eliminates a bunch of confusion and too much conversation when I get pulled over by the highway patrol, and the nice officer wants to know why the rivets look so new.
I have been delayed an even impounded once to clarify this problem. They thought I was gettin fancy with the VIN numbers. Took a few days to get the problem resolved and get my baby back. Still had to pay towing and storage too.
Talk about feeling violated. My baby had to spend a few nights in a cold and lonely towing yard.
Perhaps this is an isolated incident but now I have learned to use the factory fasteners.
Cant be too careful.
Thread
Thread Starter
Forum
Replies
Last Post
speedracer54729
1999 - 2003 7.3L Power Stroke Diesel
1
04-24-2014 12:23 PM
sthrnforddriver
1987 - 1996 F150 & Larger F-Series Trucks
8
09-21-2010 10:42 AM