7.3L non-turbo desiel push rods
#1
#2
Always best to put them back in the same place, on the same lifter/rocker arm they have worn into.
You obviously don't have that option now so just put them back in where ever.
I haven't had the pleasure of taking a 7.3L apart so check them for length differences. Intake and exhaust rods may be different in that respect so make sure you put them in the right place if they are.
Other than that you should be fine.
Oh and I always make sure none are bent just because I have them in my hand. Roll em on a flat surface real quick and make sure they are true.
You obviously don't have that option now so just put them back in where ever.
I haven't had the pleasure of taking a 7.3L apart so check them for length differences. Intake and exhaust rods may be different in that respect so make sure you put them in the right place if they are.
Other than that you should be fine.
Oh and I always make sure none are bent just because I have them in my hand. Roll em on a flat surface real quick and make sure they are true.
Thread
Thread Starter
Forum
Replies
Last Post
flipklos
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
4
01-14-2012 07:23 PM
rduncan530
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
3
11-13-2010 01:44 PM