Alabamabuddog - what was that with the x-member? An F150?
#1
Alabamabuddog - what was that with the x-member? An F150?
I know you mentioned it a couple times, and it had eighteen bolts holding it in. I keep trying to picture it in my head, and all I can think is that there must have been four bolts at each end for starters, and angle braces. Plus more stuff in the middle...
At least I can be thankful that a Ranger is more of a Mustang-like setup. Two pin bolts, and two bolts in the center. I was kinda suprised that it was offset a little bit to one side though. About an inch, if I remember right.
I think for round two, I'll be borrowing Don's transmission jack.
At least I can be thankful that a Ranger is more of a Mustang-like setup. Two pin bolts, and two bolts in the center. I was kinda suprised that it was offset a little bit to one side though. About an inch, if I remember right.
I think for round two, I'll be borrowing Don's transmission jack.
Thread
Thread Starter
Forum
Replies
Last Post
lacyctdy
1987 - 1996 F150 & Larger F-Series Trucks
4
08-29-2015 12:22 PM
f-250diesel
1994.5 - 1997 7.3L Power Stroke Diesel
4
12-31-2010 09:01 AM
Critterhunter
1983 - 2012 Ranger & B-Series
1
04-21-2010 10:12 PM