Where to get a driveshaft??
#2
Where to get a driveshaft??
Had a little problem the other day. Took the top off, pulled the back seat out, and spitshined the ole '79 for a night out, but when I mashed the loudpedal I spun the splines right out of the driveshaft!! Talk about a bummer. Locked her into four hi and limped home. My question is, where can I get a new one made up without breaking the bank?
Oh by the way, I was forced to take the '01 superduty PSD out that night. Bummer ;-);-)
BFM
Oh by the way, I was forced to take the '01 superduty PSD out that night. Bummer ;-);-)
BFM
#3
Where to get a driveshaft??
[font size="1" color="#FF0000"]LAST EDITED ON 18-May-01 AT 07:42 PM (EST)[/font][p]same for our ex 78 Bronco!
some dudes are parting out their Broncos:
http://www.broncotech.com/cgi-bin/forumdisplay.cgi?action=topics&number=2&SUBMIT=Go
AND here too:
http://www.off-road.com/cgi-bin/classifieds/classifieds.cgi
AND HERE:
http://forums.mybigbronco.com/cgi-bin/forums.cgi?forum=8
We bought a new shaft from #####'s in AZ;
http://www.dicksdriveshaft.com/
Beside your your local yards, try this site for a national junkyd. site;
http://www.copartfinder.com./cgi-bin/select.dtw/disp
Besides Broncos, I always wondered if a 4x4 pup shortbed shaft can be used, intact or by shortening, which would be cheaper than a new shaft.
Good luck!
some dudes are parting out their Broncos:
http://www.broncotech.com/cgi-bin/forumdisplay.cgi?action=topics&number=2&SUBMIT=Go
AND here too:
http://www.off-road.com/cgi-bin/classifieds/classifieds.cgi
AND HERE:
http://forums.mybigbronco.com/cgi-bin/forums.cgi?forum=8
We bought a new shaft from #####'s in AZ;
http://www.dicksdriveshaft.com/
Beside your your local yards, try this site for a national junkyd. site;
http://www.copartfinder.com./cgi-bin/select.dtw/disp
Besides Broncos, I always wondered if a 4x4 pup shortbed shaft can be used, intact or by shortening, which would be cheaper than a new shaft.
Good luck!
#4
Thread
Thread Starter
Forum
Replies
Last Post