Gday all, from down under.
Thread Starter
|
New User
Joined: Oct 2005
Posts: 7
Likes: 0
Gday all, from down under.
Gday guys,
I have just joined all the way from Western Australia in search of specific Ford trans info that should test even the most knowledgable FTE. But luckily I read the forum rules and won't post it here.
My truck is a 1972 Australia Ford Falcon 4x4 Panel Van. Ford Australia built 432 4x4 utes as an experimental project in the early 70's and a few of them were converted into wagons and Panel vans as they shared the same floor plans by both dealers and handy men alike.
I will post a few photos when I figure out how but I am off to find the best forum to post my tech questions. Anyone up for a challenge?
I have just joined all the way from Western Australia in search of specific Ford trans info that should test even the most knowledgable FTE. But luckily I read the forum rules and won't post it here.
My truck is a 1972 Australia Ford Falcon 4x4 Panel Van. Ford Australia built 432 4x4 utes as an experimental project in the early 70's and a few of them were converted into wagons and Panel vans as they shared the same floor plans by both dealers and handy men alike.
I will post a few photos when I figure out how but I am off to find the best forum to post my tech questions. Anyone up for a challenge?
FTE Leadership Emeritus
Joined: Jan 2003
Posts: 161,999
Likes: 75
From: 3rd Rock
...Welcome to Ford Truck Enthusiasts!
If you get a minute check out the link here, it will help you to navigate around and understand this site. https://www.ford-trucks.com/forums/s...d.php?t=300691
We are happy you have chosen the best source for Fords!
Enjoy FTE and The State Chapters are located at the bottom of the main forum page.
JOIN CLUB FTE -SUPPORT THE FORUMS!
See you on the boards.
….
If you get a minute check out the link here, it will help you to navigate around and understand this site. https://www.ford-trucks.com/forums/s...d.php?t=300691
We are happy you have chosen the best source for Fords!
Enjoy FTE and The State Chapters are located at the bottom of the main forum page.
JOIN CLUB FTE -SUPPORT THE FORUMS!
See you on the boards.
….
Posting Guru
Joined: Jun 1999
Posts: 2,007
Likes: 0
From: Oregon
Hi!
Make sure to say hello down in the International Forum, (scroll down on the main forums page to find). https://www.ford-trucks.com/forums/f...play.php?f=141
Make sure to say hello down in the International Forum, (scroll down on the main forums page to find). https://www.ford-trucks.com/forums/f...play.php?f=141
FTE Leadership Emeritus
Joined: May 2004
Posts: 18,787
Likes: 30
From: Melbourne, Aus
Welcome Clay..
As Howdy said, you should check out the International chapter.
A link on how to join is in my signature.
You have one rare vehicle (the Falcon ute with the 4x4 F100 running gear) - I assume it has a Cleveland?
As Howdy said, you should check out the International chapter.
A link on how to join is in my signature.
You have one rare vehicle (the Falcon ute with the 4x4 F100 running gear) - I assume it has a Cleveland?
Last edited by BigF350; Oct 31, 2005 at 05:44 AM.
Thread Starter
|
New User
Joined: Oct 2005
Posts: 7
Likes: 0
Its got mainly Jeep running gear. Dana 44s front and back, T15a, Dana 20 with a 302 Windsor. Will check out the international stuff when I get a chance. Still trying to find my around the site at the moment.
Thread
Thread Starter
Forum
Replies
Last Post
