Reverse Aid (backup) sensor transfer Q
Thread Starter
|
Senior User
Joined: Jun 2005
Posts: 167
Likes: 0
From: ABQ NM
Reverse Aid (backup) sensor transfer Q
I've replaced the factory bumper on my '05 F-250 and would like to transfer the sensors from the reverse aid system. The face on my replacement bumper is vertical; while the Ford orginal face points towards the ground. The stand-off rings on these sensors compensate for that slope; which is not needed for the new bumper.
The Excursion bumper face is vertical, does anyone know if the sensor manufacturer is the same? In fact, does anyone know who makes these things?
Or other suggestions?
The Excursion bumper face is vertical, does anyone know if the sensor manufacturer is the same? In fact, does anyone know who makes these things?
Or other suggestions?
