Milling D3VE heads...
Thread Starter
|
Senior User
Joined: Jun 2005
Posts: 176
Likes: 0
From: Temple, TX
Milling D3VE heads...
What's the most I could safely mill a set of these heads? And would I have to mill the intake or get shortened pushrods as well?
I'm trying to find the most cost effective way to raise compression on my '78 engine... I'm not sure what it is stock, but I'm sure it's pretty low. I don't want to tear the whole thing down to put in flat tops just yet either...
I'm trying to find the most cost effective way to raise compression on my '78 engine... I'm not sure what it is stock, but I'm sure it's pretty low. I don't want to tear the whole thing down to put in flat tops just yet either...
Thread
Thread Starter
Forum
Replies
Last Post
matt16875
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
17
Aug 7, 2007 10:18 AM
vsuccess
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
6
Nov 8, 2002 10:50 PM
fordtruckin
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
6
Mar 31, 2002 12:55 PM
