AEM Brute Force Cold Air intake interrupts remote start
#1
AEM Brute Force Cold Air intake interrupts remote start
I recently replaced the factory air intake system with a AEM Brute Force Cold Air Intake System. It is GREAT! But, now when I use my remote start it starts up just fine, but only remains started for a coupel of seconds. Does anyone knwo why and is there a whay to bypass this problem? Any advise would be appreciative. Thx.
#4
Originally Posted by ericbresnahan
I recently replaced the factory air intake system with a AEM Brute Force Cold Air Intake System. It is GREAT! But, now when I use my remote start it starts up just fine, but only remains started for a coupel of seconds. Does anyone knwo why and is there a whay to bypass this problem? Any advise would be appreciative. Thx.
Enjoy FTE ….
#5
I read on another thread that during a cold start in very cold weather, the engine rpms are higher and the remote start will automatically turn off the motor because it thinks there is a problem due to the high rpms. Someone said the tach can be bypassed and this won't happen. If you just installed the CAI and the weather got cold at the same time...it might not be the CAI.
Thread
Thread Starter
Forum
Replies
Last Post
nokes02
2004 - 2008 F150
12
08-28-2012 11:37 PM