Rust Problems
Thread Starter
|
Elder User
Joined: Feb 2003
Posts: 887
Likes: 0
From: MN
Rust Problems
Hi, these are the rust spots on my truck that I am not sure how to fix. I am most concerned with one on the front fender because it is under the trim tape, and both colors of paint I'm having problems getting the picture up. The dent is not a priority, but if I'm going to redo the paint on that fender, I might as well. Thanks for your help.
[IMG]
[/IMG]
[IMG]
[/IMG]
[IMG]
[/IMG] [IMG]
[/IMG]
Last edited by natewoz; Feb 25, 2004 at 06:06 PM.
[/IMG]
Senior User
Joined: Feb 2004
Posts: 118
Likes: 0
From: South Shore, MA
Take off the wheel molding, the splash shield, stripe and bodyside molding. See how far the rust has eaten through. Take the front down to bare metal and then sandblast the pits in the metal till they are clean. Now go do the same to the inside of the fender. Put some rust treatment over the areas and then put filler on the front, sand, prime, paint it. On the back just put some undercoating or even just prime and paint it.
Thread
Thread Starter
Forum
Replies
Last Post
D Sokol
1948 - 1956 F1, F100 & Larger F-Series Trucks
2
May 28, 2014 12:00 PM
