Torque Specs After Injector Replacement

Reply Subscribe

Thread Tools

Search this Thread

Jul 29, 2019 | 08:03 PM

Steve56

Thread Starter

Mountain Pass

Joined: May 2019

Posts: 106

Likes: 2

From: Old Jersey

Torque Specs After Injector Replacement

I need to replace the injectors in my '07 F350 after one injector let loose (nearly flooding the cylinder) and will likely begin the job tomorrow. I'm looking to see if anyone could tell me or provide some info on the correct torque specs for:

Injector hold downs
High pressure oil rail
Oil rail standpipes and dummy plugs
Valve cover studs

Would greatly appreciate the time anybody takes to clear this up. Don't have access to my service manual at the moment, but I believe it stated the valve cover studs need to be torqued to (80 lb-in) even though everything else that has a torque spec is listed in lb-ft. Just want to confirm the figures, as, for example, the torque specs for the valve cover studs/bolts given in several YouTube videos is different than certain sources I've read.
Thanks!