How much improvement is the 2017+ model SC's back seat over 2011-16 SC's? I have a 2016 F250SC and looking to replace it with a 2020 but not sure if I should go SC or CC..... The SC will still fit in my garage (barely) but would like a bigger backseat even though it isn't used much.

 

 

 

It definitely is. Kinda bummed, was eyeing this one. Pictures on the site make it seem much thinner and more tucked to the truck than it does here. Maybe its the angle, but that seems to stick out far (I know it needs to fit a winch )

 

Robert, which bumper set up is that?

It is indeed a Fab Fours Premium winch bumper! It's a very solid bumper and has extra angles in it so it stays tight to the truck and does not stick out too far like some of the other winch bumpers.

 

Any chance of a side view? I am interested in getting a winch on my f350 and shopping bumpers - but many stick out way to far for my taste. That angle makes the fab 4 seem to stick out a lot (vs the pictures on their website) possibly a bad angle. Thank you!

 

 

My 17 XLT LB Gasser


Typical day in the neighborhood

Headed out for some Ducks

 

 

 

 

 

 

 

This is actually my second bumper. I was in an accident with the old bumper. It was a lower speed crash but the bumper prevented a ton of damage to the front end of the truck. The bumper was trashed but the only damage to the front end of the truck was the quarter panel and headlight assembly. If I had the factory bumper, there would have been damage to the grill, hood and fluid coolers behind the grill and the adjuster agreed. If I had the full wrap guard, I believe the headlight would have survived too. I almost went for the full gaurd but it is huge and I didn't care for the look of it but if you want maximum protection, it is the way to go.
I hope this helps.