Cracked Bell Housing
#1
Cracked Bell Housing
Good Day Group.....
I have a qwik question about cracked bell housing , 2005 F150 4.6L 4x4 Auto. I've had MANY mixed responses from friends just wondering opinion from any experts in this field.... Had trans out to install new input seal, during installation TC was not in far enough and while tightening bolts broke 2 sections off..... ( Refer to attached picture) . Was told not to worry as breaks were "pulled " away , However also was told Due to high frequency / load / bumps or bouncing they may spread..... Anyone ever run into this? I might need to use it for dump runs and just wondering if safe to use... other than that its going for sale as is $800 .....
Thanks....
I have a qwik question about cracked bell housing , 2005 F150 4.6L 4x4 Auto. I've had MANY mixed responses from friends just wondering opinion from any experts in this field.... Had trans out to install new input seal, during installation TC was not in far enough and while tightening bolts broke 2 sections off..... ( Refer to attached picture) . Was told not to worry as breaks were "pulled " away , However also was told Due to high frequency / load / bumps or bouncing they may spread..... Anyone ever run into this? I might need to use it for dump runs and just wondering if safe to use... other than that its going for sale as is $800 .....
Thanks....
#2
Thread
Thread Starter
Forum
Replies
Last Post
85bullnose250
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
11
05-18-2018 10:40 PM