What do I need for a 8.8 rear end swap?
#1
What do I need for a 8.8 rear end swap?
Hey. May be a stupid question im asking here but I have a 1990 bronco (actually it as a VW body on top, @that_vw_bronco get that plug) I want to do a 8.8 rear end disc dwap. What do I need to do this? It's a 1990 bronco, I would guess new driveshaft, what other parts besides brake lines? How hard are putting new brake lines in? what kind of fab do I need to do? Thanks
If anyone has done this before (im sure they have) I would love to hear your input!
If anyone has done this before (im sure they have) I would love to hear your input!
#2
you already have an 8.8 rear diff. doing rear disc will require a kit, broncograveyard has one that is correct i believe. Just pay attention to the disc bolt pattern, you need 5x5.5 anything else will need redrilled. since you have a 90 you could also do a 9inch swap.
just make sure the diff ratio is the same or very close to the front ratio
just make sure the diff ratio is the same or very close to the front ratio
#3
you already have an 8.8 rear diff. doing rear disc will require a kit, broncograveyard has one that is correct i believe. Just pay attention to the disc bolt pattern, you need 5x5.5 anything else will need redrilled. since you have a 90 you could also do a 9inch swap.
just make sure the diff ratio is the same or very close to the front ratio
just make sure the diff ratio is the same or very close to the front ratio
Thread
Thread Starter
Forum
Replies
Last Post
Bootlegger's Deluxe
1987 - 1996 F150 & Larger F-Series Trucks
19
11-27-2012 06:14 PM
Violjohn78
Clutch, Transmission, Differential, Axle & Transfer Case
2
03-03-2003 09:43 PM