Hello Everyone
Thread Starter
|
New User
Joined: Oct 2018
Posts: 4
Likes: 0
Hello Everyone
My name is Bill and I am in desperate need of people with a lot more knowledge than I have. In my search for a place with possible answers I found these forums and here I am. I have a 1998 Mazda B-3000 and my pulse vacuum hubs are non functional. What I really need to know is about a conversion that I know can be done on a Ranger with these hubs, but not sure if it can be done with my Mazda. Its the live axle conversion where you take the axles and hubs from a 95-01 Ford explorer and put them into the ranger. That way bypassing the need for locking hubs all together due to them always being locked. I was just wondering if this same conversion could be done with my 1998 Mazda B-3000. Thank you all very much for your time and I'm happy to be here.
Laughing Gas
Joined: Apr 2011
Posts: 1,083
Likes: 19
From: North Shore, MN.
Welcome to the FTE Bill 
I'd post this here for a quicker reply
Ranger & B-Series;
https://www.ford-trucks.com/forums/forum35/
I'd post this here for a quicker reply
Ranger & B-Series;
https://www.ford-trucks.com/forums/forum35/
Thread Starter
|
New User
Joined: Oct 2018
Posts: 4
Likes: 0
Welcome to the FTE Bill
I'd post this here for a quicker reply
Ranger & B-Series;
https://www.ford-trucks.com/forums/forum35/
I'd post this here for a quicker reply
Ranger & B-Series;
https://www.ford-trucks.com/forums/forum35/
Thread
Thread Starter
Forum
Replies
Last Post
