New to Ford and Vans
#1
New to Ford and Vans
Picked up a 92 Ford E350 with the 7.3 NA diesel in it. Planning on converting over to 4x4 and raise the roof and all that jazz. In the mean time I'm trying to clean up the old girl.
Right now it uses 3 different keys for the doors and ignition. I see key sets for 96+ vans but limited on older ones. Will these sets work on this van? I know the newer ones use a 8 pin key vs the 10 pin key. I'd like to get all the doors and ignition to match.
Also general places to find plastic and rubber bits. All the weather stripping is crap and most of the plastic is garbage. Any general advice on this?
Right now it uses 3 different keys for the doors and ignition. I see key sets for 96+ vans but limited on older ones. Will these sets work on this van? I know the newer ones use a 8 pin key vs the 10 pin key. I'd like to get all the doors and ignition to match.
Also general places to find plastic and rubber bits. All the weather stripping is crap and most of the plastic is garbage. Any general advice on this?
Thread
Thread Starter
Forum
Replies
Last Post
GreenMM
WTB - Ford Trucks & other vehicles
3
02-09-2017 12:09 PM
GreenMM
1968-Present E-Series Van/Cutaway/Chassis
33
11-03-2016 08:42 AM