No cold start even with starting fluid
#1
No cold start even with starting fluid
So as the post read, below 20F my 2011 5.4l will not start unless the block heater is plugged in. After that it starts all day. I have read a little about IATs and can and crank sensors, not sure what to try next. Probably unrelated, the blower motor is loud, but hardly any air blows out the vents, (blend door?) Any help is greatly appreciated
Last edited by miteymt; 01-06-2018 at 08:57 AM. Reason: Missing info
#2
#3
#5
Yes new spark plugs will help a lot. The misfires might be due to the plugs and not the COPs. The cheaper solution is to buy a new boot/spring kit for your COPs and change them when changing the spark plugs. Most misfires are due to the boots cracking and allowing spark to jump through to the heads.
Thread
Thread Starter
Forum
Replies
Last Post
Firefighter 1406
1997-2006 Expedition & Navigator
15
12-28-2014 08:56 PM
FordManMT
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
14
03-13-2013 10:58 PM
PSDlongbox
6.0L Power Stroke Diesel
11
09-15-2012 02:09 AM