rear fender bracket
#1
rear fender bracket
I've always found what I needed in older posts, y'all are amazin... but couldn't locate info on this little problem. I purchased rear fender brackets and they don't seem to line-up so well. Could anyone post a photo of how they've mounted the replacement brackets forward of the rear wheel? The replacement parts don't marry-up well with the edge of the fender or the bottom of the bed.
Curiously DC representative told me they didn't have this part, so I purchased from NPD. It arrived wrapped one plastic bag inside another. The inner bag marked, "MADE IN CHINA" - the outer bag had a DC label with part # BAAA-16340-A, with a NPD label over that with part # F-16340-1.
1969 F-100, 360
Curiously DC representative told me they didn't have this part, so I purchased from NPD. It arrived wrapped one plastic bag inside another. The inner bag marked, "MADE IN CHINA" - the outer bag had a DC label with part # BAAA-16340-A, with a NPD label over that with part # F-16340-1.
1969 F-100, 360
#2
I've always found what I needed in older posts, y'all are amazin... but couldn't locate info on this little problem. I purchased rear fender brackets and they don't seem to line-up so well. Could anyone post a photo of how they've mounted the replacement brackets forward of the rear wheel? The replacement parts don't marry-up well with the edge of the fender or the bottom of the bed.
Curiously DC representative told me they didn't have this part, so I purchased from NPD. It arrived wrapped one plastic bag inside another.
The inner bag marked, "MADE IN CHINA" - the outer bag had a DC label with part # BAAA-16340-A .. with a NPD label over that with part # F-16340-1.
1969 F-100.
Curiously DC representative told me they didn't have this part, so I purchased from NPD. It arrived wrapped one plastic bag inside another.
The inner bag marked, "MADE IN CHINA" - the outer bag had a DC label with part # BAAA-16340-A .. with a NPD label over that with part # F-16340-1.
1969 F-100.
2) BAAA-16340-A .. Rear Fender Brace / Reproduced
1953/56 F100/350.
----------
2) B7C-16340-A .. Rear Fender Brace - bent channel type - 15" developed length - lower rear fender to frame / Obsolete
1957/72 F100/350 Flaresides.
I don't know if this has been reproduced. No Ford dealer or obsolete parts vendor has any.
#3
#5
Thread
Thread Starter
Forum
Replies
Last Post
revamp1953f100
1948 - 1956 F1, F100 & Larger F-Series Trucks
6
04-08-2019 08:55 AM
crrnchris
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
7
07-01-2017 09:07 PM
53choptop
1948 - 1956 F1, F100 & Larger F-Series Trucks
3
04-04-2002 05:50 AM