When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Just did a Kooks full exhaust install on our welders 2004 Lightning. All went pretty smooth and Kooks quality is pretty darn good! the only I could complain about was that the dual tailpipes were a little off in the bend going into the mufflers. (Had to give it a little help!) Other than that....we had to overnight O2 sensor extensions for the front O2 sensors.
Here are some pics!
Getting ready!!
Factory exhaust out!
Nice!
Passenger side. Had to remove the starter harness to get the header in from the top.
Built in X-pipe. All stainless!
O2 sensor was a little close to the trans, but got it installed.
08-19-2017, 08:07 PM
