360 FE rebuild cambearings
#1
360 FE rebuild cambearings
Hi
im rebuilding a 360 for my f 250 truck and have a question about the 1st cam bearing .The new cam bearing that goes in to number one spot(front) has to holes and a grove between them there is also a grove going 90 deg from one of the holes and i cant figure out if that it supposed to go towards the thrust bearing plate (front) or backwards. The old bearing did not have this grove
Hans
im rebuilding a 360 for my f 250 truck and have a question about the 1st cam bearing .The new cam bearing that goes in to number one spot(front) has to holes and a grove between them there is also a grove going 90 deg from one of the holes and i cant figure out if that it supposed to go towards the thrust bearing plate (front) or backwards. The old bearing did not have this grove
Hans
#3
There was a fairly extensive thread recently about FE engines and cam bearings. Might want to give it a read too.
https://www.ford-trucks.com/forums/1...s-2-times.html
https://www.ford-trucks.com/forums/1...s-2-times.html
Thread
Thread Starter
Forum
Replies
Last Post
wyrm73
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
10
11-28-2017 10:40 AM
Lisa Convey
1973 - 1979 F-100 & Larger F-Series Trucks
0
03-02-2016 06:27 PM
1975FordF250
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
4
04-19-2014 09:34 AM
mlf72f250
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
7
06-20-2003 11:04 PM