Hello Jim..

 

Tires holding up good?

 

Good morning John

 

I'll be doing the driveshaft thing soon too minus the rust...lol

 

You couldn't either, that is what cameras are for Of course Pat isn't sharing any of his

 

I was hoping to rid the vibration. As soon as I took it off, I didn't think the U joints were a problem. It has had it for a long time, maybe before we bought it. You can start to feel it around 50 and gets worse, probably feel it more on coasting. Guess I'll have to see if any place around in Vermont can balance one.

 

Oh, but I can, all locked inside my tiny brain!!LOL

Morning Jim!

Well, it's a little tough carrying my phone in a water park. I phones typically don't like getting wet.

 

What about a center bearing, did you check that..

 

The Rotiiva AT Plus have held up extremely well considering they were loaded almost to max weight and were on some pretty terrible roads. Chip seal is like sandpaper to tires. I have 80% left on the rears (swapped from front at 7,000 miles in Missoula, MT). Fronts are at 60%. I was hoping to rotate a bit sooner but few places could handle the truck with the camper on and I didn't want to take it off.

 

Uh, ever heard of go pro? duh could have strapped it to your helmet, no one would have noticed LOL

 

No center bearing, one piece shaft

 

Should get you through the winter

 

Maybe that cat you ran over is still hanging on tight... lol

 

Evening Jim, Shawn, John, Don and anyone that I missed.

 

Hello Neil..