May discussion on buoyant trucks and entuhlekshual interaction
#301
good morning missouri.. rich i would love to have a lift.. i would like to do a oil change in the black bronco.. it looks like i have to pull the engine out to get to the filter
i got my rebuild parts for the 460.. i may get the short block built, then decide what to do about the heads later.. as always this quick repair is turning into a lot more than originally planned.. i am way to deep into it to quit..
i dont know if i am tough enough to retire at this time.... i think being POOR is worse than being TIRED !!!!!!
i got my rebuild parts for the 460.. i may get the short block built, then decide what to do about the heads later.. as always this quick repair is turning into a lot more than originally planned.. i am way to deep into it to quit..
i dont know if i am tough enough to retire at this time.... i think being POOR is worse than being TIRED !!!!!!
#302
#303
Afternoon All!
Rich. If I had a bay door for each bay in the shop, I would consider a lift, but having one door at the end of the shop, a lift just takes up way too much space.
RC. I feel your paint. I'll need to put three of those 460s together here in the near future. While I'm going to enjoy driving them, it's gonna sting a little to build them. (2 of them need to thump pretty hard when they're done)
I hurt too bad to stay all day at work. I pulled Pat's Eagle in and started on that. That's gonna be a challenge. A lot of the parts that are broken, need to be fabricated since not many of the parts stores are stocking stuff for 30 year old AMCs.
Rich. If I had a bay door for each bay in the shop, I would consider a lift, but having one door at the end of the shop, a lift just takes up way too much space.
RC. I feel your paint. I'll need to put three of those 460s together here in the near future. While I'm going to enjoy driving them, it's gonna sting a little to build them. (2 of them need to thump pretty hard when they're done)
I hurt too bad to stay all day at work. I pulled Pat's Eagle in and started on that. That's gonna be a challenge. A lot of the parts that are broken, need to be fabricated since not many of the parts stores are stocking stuff for 30 year old AMCs.
#304
Evening folks, June's new thread is up and running. https://www.ford-trucks.com/forums/1...l#post17229960
Come on over tomorrow.
Come on over tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
glruff
Mid-Atlantic Region
114
09-25-2009 09:41 PM