90 ranger 2.3 hesitation problem
#1
90 ranger 2.3 hesitation problem
I have 1990 ranger 2.3l 5speed with 170000miles. Truck runs fine, but after 5-20 minutes (it's never consistent ) it looses power, hesitates, burns more gas and jerks when let off pedal. CEL will come on and it runs a little better with it on and black soot at tail pipe. I have not had it's codes read yet. Any ideas of a sensor bad or what it is. can a cat going bad cause it or would it do it all the time if it's clogged? Turn it off and reset the CEL and the process starts all over again.
Thread
Thread Starter
Forum
Replies
Last Post
supermandn59
1983 - 2012 Ranger & B-Series
1
02-17-2011 07:38 AM