Hi to everyone,

A while ago i rebuild the fresh-air heater of my 1975 F250 and added a new heatercore.
Later when i put the whole heater assembly back to its place, i noticed to sealings i was not able to "rebuild" with my material (sealing for electrical cabinets), because they got a special form.
Weekend for weekend i'm trying to find informations on google or here in the forum, but i'm not able to find them...

Maybe a nice guy helps me to find a number, a name (i even dont know how to call it in english) or a shop!

I will attache a picture where i marked the two sealings with a red circut
-One from assembly to defroster
-One from fresh-air-input to the vent-box

Otherwise i will try to use other material to rebuild these sealings, but i like parts which are fitting directly more


Thank u guys and have a good one!

 

There may be some of those pieces either in reproductions or NOS......but I doubt it......I have successfully used foam weather-stripping with an adhesive back in the past for both of your applications....

 

Hi 78 PEB

My electrical-cabinet sealing is nearly the same like your foam and i replaced all the other sealings with it, but at the moment i got no material by the hand, which is thick enough for the positions i need it.
For the defroster i have to pass somethink like 0,75inch (20mm) and i don't like to build a "tower" with this "foam".
So your solution is already in my head, but i would like fitting parts more