it just leans forward.


Today I picked up a pair of 2015 tan leather 10 way powered seats for 400 bucks. now I have to figure out how to wire the darn things

 

F350 4" rear blocks in place of my 2" stockers and 2" mini-pack front leveling kit installed. Now for tires.

 

Man that's a good looking truck talk about a cream puff.

 

@Pony sharp truck.

How much did the F350 blocks and U-bolts run?

 

Blocks are ReadyLift 66-2294 (flat 4" for trucks with 2 piece driveshaft, I got em for $140 which was cheaper than every other seller on ebay but I see now that the price has gone up LOL
ReadyLift 66-2294 4.0 in. Block Kit | eBay


The front kit is from this guy and is basically four 1/2" steel plates with center bolts, u-bolts and hardware. It is listed as a 2.8", and I questioned him about it as it is only 2" of plates per side. He said some trucks with springs flexed backward can see that much. My springs are flat as they are installed so I saw 2".
99-04 FORD F250 2.8" Front Leveling lift kit F-250 | eBay


Gonna put 315/75-16 BFG KO2s on it. Had 315s on my old SD and liked them.

 

Do not like a lot of chrome. Took off the running boards, popped off all the plastic, sanded them down and coated with DupliColor bed liner. Like the results. Photo is of the one I did a few weeks ago so it's a little dirty in the photo

 

Finished up some lighting. Added rock climbing light for added back up lights and front side lights. Also wired it so I can switch the back up light on from the bed for added light at night. Will add a few more under the running boards. Switches are for cap lights, backup lights, running board lights and a spare. Also added a hood ornament.

 

Nice!!!!!!

 

Early 99 y-pipe and added my take off 2.5" hitch


The 99 y-pipe was much longer so i had to cut the mid pipe and reweld it

Its so sexy

 

Gave 'er a much needed bath.
​​​​​​​

 

I was going to grease my truck, but I ran out. What brand and type of grease does everyone use for the front end, u joints, and hubs?

 

I left it stock longer than my last one but I missed having a lifted truck. A little more subtle this time.

 

Had to install fender flares to pass PA inspection.
​​​​​​​

 

You passed, you can take them off now. Lol.

 

Yea part of me wants to take them off but part of me actually kind of likes the flares. If anything it'll stop the horrible paint chipping I've been having.