Category: Accessories
Price: $10
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): Fit, S2000
Item Condition: OR
Shipping Information: Item can be shipped
Engine: Part suitable for gas truck

parting out 86 ranger- dash, coulmn, wiring, two 5spd trans (one has bad 1st gear), a spare manual t-case, 2.9 liter engine, 2 radiators (one new autozone used 6 weeks and other unknown used...both with shrouds), ac/heater box, front split bench, pedal assembly, used 3" body lift, computer, and maybe more let me know and i'll tell you if it's availible...

parting out 92 explorer, pulled motor, trans, front seats, wiring, computer, radiator, dash, computer, rear axle and fuel tank to put into above ranger... that leaves the complete body (dent in lower rear passenger door), rear seats, front clip, both bumpers, front axle, auto t-case, auto hubs and a few other misolaniuos parts...

heres the cool part... taking any reasonable offer on any part i have availible... seriously shoot me a decent offer and the part is yours.... pm me and i'll get back to you..

 

im looking for 4 aluminum rims 16" to fit a 97 explorier. do you have them?

 

no no extra rims right now 15 16 or otherwise plus 16s are hardest to get.

 

do you have some dana 28 axles I need some asap, give me a pm if you do have some thanks

 

what parts do you need please specify then i can tell you thanks

 

front axleshaft the passenger one. and depending on price maybe the driver side.

 

10 bucks a pice plus shipping whats your zip code and when

 

i'll pay now and take all of the front ones. do you have pics. my cell. 413-627-six seven seven nine. please call as soon as you have a chance

 

sorry stupid cell phone didn't show last post.

 

do you still have the bodylift if so send me a pm

 

hows the trans for the explorer? i have an 96 4.0 that needs a trans

 

pm sent in regards to the bodylift and as for the tranny 2 points...one the 92 trans and 96 are differant... second after i change the filter it goes in the ranger project along with the 4.0....can get you one locally from my wrecking yard hookup...

 

i need the fuel return line for the pressuse regulator to the lines near frame rail, they have high pressuse fittings on them.

thanks

 

have the set from the 86 ranger but not from the explorer... can get them from the llocal wreckers though...

 

Hi,
I am looking for the composit rubber drive shaft coupler for my 88 ranger. Got one of these left?

Thanks