I am installing my new 4R70W trans and wondered if anyone had any tips or advice on installing, filling trans fluid and breaking it in, this is on my 2001 E-250. any help would be appreciated

 

Once it's installed put 8 quarts in it, then run the engine for 60 seconds and shut it off. Add four more quarts and start it again. Let it run to warm up. Move the shift lever to each position and then check the trans fluid level. Use the dipstick to set the level.

 

Do I need to add any fluid to the torque converter before I install it?

 

No, you do not.

 

Installed new- rebuilt trans by ford with three year warranty last weekend, was informed that unit cane filled with fluid. Trans went in pretty well, also installed new catalytic converter's both left and right side. Truck runs fantastic now which was quite a relief, was starting to think I needed a new motor. Amazing how the computer can make you think the worst!