When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Yup, that's where it started for sure Gerry. XLR has this problem on many of their fenders. They all come through with indents to show where to screw but no one bothered to pre-drill them before screwing through. After a year or two of flapping in the wind, they start to split from the screw hole out...
Late this afternoon we settled into a campground between Bath, Maine and Popham Beach, ME......
We will be here until Sunday. Then on to Bar Harbor, ME and the G2g.......
Great area Roy. What campground are you in? Is it on or near the water? You're right on the coast there again...
Morning everyone.... Rain here the next three days which is outstanding as we are getting it over with before ME. Hoping to lock in the current forecast for next week...
Slideouts.... love them and hate them (maybe 25/75 ). Pretty tough to make a structurally sound unit after punching giant holes in the side of it. I have some small 1" cracks in the fiberglass skin at the lower corner of one of my slides. If I fix it it'll just return so I seal it.
I used to watch in the mirror as one section of a fender flapped in the wind. I had to JB weld where it cracked around the screw and then I put a metal support behind it to stop it moving.
Morning everyone.... Rain here the next three days which is outstanding as we are getting it over with before ME. Hoping to lock in the current forecast for next week...
When we are done with the rain here in Wisconsin, we like to send it your way. Local flooding this morning here. Been raining a lot lately. Farmers must be happy.