When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am removing the cross member that supported my Y block. Some of the steel rivets I could reach with a grinder or cutoff wheel and had room to pound out the post. Most are in a position that I can't do that top or bottom. How did you guys get those pesky {impossible} ones out? Special tool, special technique? Thanks
I really dislike doing them with the cab on, and they are not that much fun with the cab off. I have 2 that need removed from frames that are toast.........maybe after a few frosties I'd be more excited about removing them