Injector line.
#1
Injector line.
Holy cow. Had my Injector pump off for return line fittings and O-ring replacements. When I was cleaning up the pump and injector lines I noticed some wear on the steel line for cylinder # 8. A hole almost rubbed half way thru the steel line. Source of problem was the Cruise control cable was routed over and laying on the steel line. Over time the ribbed cable sheath had acted like a saw and was cutting the line in two. (Not leaking yet.)
I rerouted the cable to go under the injector line.
Local International dealer can get me the one new steel line for about $140.00. and wait time.
Hydraulic shop across the street from the dealer can make me one for about $60.00 when I take the bad one in for a pattern to follow. Same day service.
Posting this for others to check on their rigs before they have same problem.
I rerouted the cable to go under the injector line.
Local International dealer can get me the one new steel line for about $140.00. and wait time.
Hydraulic shop across the street from the dealer can make me one for about $60.00 when I take the bad one in for a pattern to follow. Same day service.
Posting this for others to check on their rigs before they have same problem.
#4
Thread
Thread Starter
Forum
Replies
Last Post
Franklin2
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
18
09-19-2009 01:12 PM
slspokane
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
6
10-23-2006 08:50 PM