Removing step side bolts from side panels
#1
#3
The original bolts "bite" into the sheet metal. To get the fiberglass fenders off, set your ratchet to tighten them and snap them off.
Then get a socket with the opening BIGGER than the heads on the inside, put the socket over the head and slam them out from the other side.
I'm doing this right now to on my 84 Flareside.
Or if you have a blue-wrench heat the steel, and the bolts "pop" out with a light tap.
Then get a socket with the opening BIGGER than the heads on the inside, put the socket over the head and slam them out from the other side.
I'm doing this right now to on my 84 Flareside.
Or if you have a blue-wrench heat the steel, and the bolts "pop" out with a light tap.
Thread
Thread Starter
Forum
Replies
Last Post
g84t8f1
1948 - 1956 F1, F100 & Larger F-Series Trucks
2
03-11-2009 01:18 PM