timken rear axle
#16
The 5.14/1 was the standard ratio, and 5.83/1 the optional ratio. On my Dana 70HD the axle had flat faced perches that worked with lower saddles to secure the 4" tubes to the springs. The stock springs would work fine. There probably would be need to grind small notches on the impeding side of each perch to allow the hangers to sneak past without bending them. Stu
#17
Thread
Thread Starter
Forum
Replies
Last Post
jmadsen
1948 - 1956 F1, F100 & Larger F-Series Trucks
5
11-29-2014 11:19 AM
Fire57
1957 - 1960 F100 & Larger F-Series Trucks
2
10-29-2014 09:29 AM
dans 51 f2
1948 - 1956 F1, F100 & Larger F-Series Trucks
1
03-17-2010 03:44 PM
390GT
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
3
02-27-2002 03:55 PM