Edelbrock polished tunnelram for SBC
#1
Edelbrock polished tunnelram for SBC
Fits SBC
I bought this for a Rat project that never happened. It's an Edelbrock polished 2-piece tunnelram intake with dual Holley 450's and a polished scoop. This intake was on a show truck since new and hardly run. I went through and did a cleanup polish on the intake and scoop. I bought new chrome carb studs and new gaskets when I reassembled the intake and for the carbs to intake. I made sure to loctite the bolts and torque them for the upper/lower intake.
$800 takes it all. It's the intake in my avatar.
540-223-3785 Paul.
I will send pics via phone
I bought this for a Rat project that never happened. It's an Edelbrock polished 2-piece tunnelram intake with dual Holley 450's and a polished scoop. This intake was on a show truck since new and hardly run. I went through and did a cleanup polish on the intake and scoop. I bought new chrome carb studs and new gaskets when I reassembled the intake and for the carbs to intake. I made sure to loctite the bolts and torque them for the upper/lower intake.
$800 takes it all. It's the intake in my avatar.
540-223-3785 Paul.
I will send pics via phone
Thread
Thread Starter
Forum
Replies
Last Post
montana_highboy
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
2
09-01-2011 06:13 PM
lud04X
Fuel Injection, Carburetion & Fuel System
4
07-13-2007 02:56 PM
dtherren
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
05-10-2006 12:02 AM