Rear axle xhaft fighting me all the way in
#1
Rear axle xhaft fighting me all the way in
Does anybody have a tip to install back the axle shaft (it's the Dana 44 in my truck, instead of the usual 8.8)? it goes very well all the way up to the last inch, then it won't budge. I've tried turning and pushing without luck, I've used a hammer and it's done nothing, it seems like it turns the differential yet the splines don't match perfectly... It's making me crazy!!! .
#3
Remember, my truck was assembled in Venezuela, were Dana has a factory and made these for the F-150/Bronco of my gen. The Dana 44 uses a retainer plate, not C-clips. And stupid me, the axle was in place all along and I was beating and cursing on it like crazy... The stupid seal had slipped out.
Thread
Thread Starter
Forum
Replies
Last Post
jav409
Clutch, Transmission, Differential, Axle & Transfer Case
1
12-06-2004 07:09 PM
blockson98
Clutch, Transmission, Differential, Axle & Transfer Case
3
04-08-2004 10:08 PM