I'm in for lunch. Ugh. I feel like I got hit by a truck.

I got a set of four ball joints done on a 1 ton dually this morning and I'm halfway through a power steering pump on the same truck. ....I just don't feel like working today, but the bills don't care how bad I feel.

 

MRI done and waiting to hear what doc says....The prlim is there is definitively something wrong in there.

 

I feel fer ya Rich.... I hope it's nothing bad, I've been through injections, and Shock test's, therapy ( Hey I've been drunking for a bit ) But I do hope you don't have to go through anything that me and my buddy Terry in Nixa have been through. Him worse than me.

Unk Bob

P.s. Waiting sucks....

 

Rc Is that Articulating??? I've spent more than a few hours on an Articulating machine.

 

Hope everyone is doing great, Got Ol Big Red moved around the house so I can see him everytime I leave or come home, Im getting stoked to make him a better truck.

 

the place where I used to work at had one it was JD544. with forks on it. and they are a pain to work on.

 

Evening all!

I got though today and I have a doctor's appointment tomorrow morning with my gastroenterologist.

I also got the cooling fans hooked up and working tonight. As soon as I get the new trans and carb on there, I should be ready for the parade.

 

Alan any chance you could come up before sat? I might be leaving Sunday, depending on my back....

 

I'm already taking off too much time from work. I really can't. Does this mean you're feeling better??

 

Hello all, new to the forum, from KC. Should be putting my .02 in here every now and then. Nice to meet you all!

 

Rich
If your leaving and need someone to hold onto the trans I can pick it up and keep it till sometimes alan can get some time off.
Larry

 

yes bob it is a articulating loader..

alan if'n ya need a hand i could come up this weekend and help ya wrestle the transmissions out.. i stayed in the shop today and moved things around, and did a little cleaning..then made some tools to make some checks the loader trans..still hoping it is not the reverse clutch's or pressure plate seals..i can get it apart still in the machine but going back together may prove difficult.. dropping them in while horizontal is a snap..but i have never tried getting the splines on the disc's lined back up while vertical..

 

nice to meet ya tcopp... come on in and hang around a bit.. most of the guys here are ok..

 

Good Morning Missouri

 

Welcome to our disparate group of try to do Wells. We try and help one another out and enjoy bs'ing in the monthly thread. One of us gets lots of wrenching done...Earthquake.