had a rough evening, and a question about a valve cover gasket.
#1
had a rough evening, and a question about a valve cover gasket.
well it all started around 5PM. i got my new aluminum ford racing valve covers and fel pro gaskets. so, i start the teardown and it goes easy. get the valve covers off and the old gaskets were TRASHED. now its time to start re-assemby. i get everything cleaned up nicely, lay down the RTV and the new gasket, and finally the valve cover. well wouldnt ya know, the new valve covers have a thicker flange and the stock bolts are too short! so here i am, running around trying to find longer bolts. and i tell ya, if youre going on an emergency parts run at 6:30PM, youre gonna have a bad time. i finally find what i need but by the time i get home the RTV has set and the cover wont budge, now i gotta rip it off and start all over again tomorrow. needless to say, im a little irate and in need of a beer or 20 right now! you guys think ill be able to re use the gasket?
#3
Thread
Thread Starter
Forum
Replies
Last Post
NashvegasMatt
1967 - 1972 F-100 & Larger F-Series Trucks
21
09-08-2016 07:09 PM
CharlaineC
1967 - 1972 F-100 & Larger F-Series Trucks
6
10-25-2014 04:35 PM
Bully350
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
4
06-29-2011 12:14 PM
tealboy1
1987 - 1996 F150 & Larger F-Series Trucks
7
12-26-2008 11:43 AM