Took the cover off the fuel/water separator on my 6.4l to clean out the bacteria farm in there. However, in cleaning out the inside of the separator I knocked several parts out of the inside of the top of the unit. They look like a plunger assembly - a small round black plastic piece with a spring on it and what is best described as a small round brass plug. I cannot find a diagram anywhere that shows the correct way to have them oriented to put them back in. Can someone help?

Here are the three parts:


Here is how I think they go together:


Can anyone point me to a parts drawing or schematic, or tell me "yep- that's how they go" ?

Thanks,
Ted

 

A little bump after adding the pictures. Can anyone help? I don't want to put it back together until I'm sure of the correct way to put these back in, so I'm just sitting here with my truck out of service. Any help would be greatly appreciated.

Thanks,
Ted

 

Hi Ted,

I don't think I've heard of this happening before, but I'm sure someone has. I'm going to send this one down to the 6.4L Powerstroke forum, you may have better luck there.