Numerous 460 big block engine parts and E4OD Transmission for sale
#46
Category: Accessories
Price: $1
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): Fit, S2000, Motorcycles, Hybrids
Item Condition: IA
Shipping Information: Item can be shipped
Engine: Part suitable for gas truck
Thanks
#49
Breather tube has been shipped.
I ran out of room in the garage from a scrapping project last week so will need to dump some stuff or it gets sent off to the scrap haulers later in the week.
Looking to dump the pistons, the 1986 intake manifold, 1996 accessory brackets, and 1996 exhaust manifolds for cheap otherwise they might be going to the scrap yard.
I ran out of room in the garage from a scrapping project last week so will need to dump some stuff or it gets sent off to the scrap haulers later in the week.
Looking to dump the pistons, the 1986 intake manifold, 1996 accessory brackets, and 1996 exhaust manifolds for cheap otherwise they might be going to the scrap yard.
#51
It will be tomorrow or Tuesday before I can get a price. Due to the awkwardness of the intake and horn setup I might have to ship them in separate packages. I will get prices for both options when I get the chance.
#53
The oil pan isn't for sale for the time being. I might need it for my existing 460 as the oil pan on that engine is rusty and pitted.
I got your PM. My next day off is tomorrow so I will get a chance to weight the parts and get you a shipping quote at that time.
I got your PM. My next day off is tomorrow so I will get a chance to weight the parts and get you a shipping quote at that time.
#55
$40 for the pair plus shipping, I'll try to include the bolts holding on the accessories.
#57
You should have a PM response.
As for the rest:
I found or am re-listing the following parts to consolidate post. All parts from from 460 engines unless otherwise specified.
Two radiator fans/clutches from both a 1986 and 1996 engine, Make Offer
1996 Piston and connecting rods with bolts, 7 available, make offer on 1 or more.
1996 and 1986 exhaust manifold sets, make offer.
F3TE heads, 1996, asking $125 each or $200 for both.
1996 valve covers, center bolt, cast aluminum, OEM, make offer.
1986 valve covers, edge bolt, OEM, make offer.
Breather tubes, airbox to intake for 1996, make offer.
1996 coil and mounting bracket with various emissions clutter, make offer.
Holley OEM carb that came off of the 1986, taken apart, most parts are still with it, make offer.
Oil pickup tube/screen and oil pump if you want it, make offer.
Full set OEM lifters and push rods for them, make offer for 1 or more.
Due to my job my responses to PM's might be a little slow. I will list more as I sort through the mess in my garage.
As for the rest:
I found or am re-listing the following parts to consolidate post. All parts from from 460 engines unless otherwise specified.
Two radiator fans/clutches from both a 1986 and 1996 engine, Make Offer
1996 Piston and connecting rods with bolts, 7 available, make offer on 1 or more.
1996 and 1986 exhaust manifold sets, make offer.
F3TE heads, 1996, asking $125 each or $200 for both.
1996 valve covers, center bolt, cast aluminum, OEM, make offer.
1986 valve covers, edge bolt, OEM, make offer.
Breather tubes, airbox to intake for 1996, make offer.
1996 coil and mounting bracket with various emissions clutter, make offer.
Holley OEM carb that came off of the 1986, taken apart, most parts are still with it, make offer.
Oil pickup tube/screen and oil pump if you want it, make offer.
Full set OEM lifters and push rods for them, make offer for 1 or more.
Due to my job my responses to PM's might be a little slow. I will list more as I sort through the mess in my garage.
#58
Damn, wish I had noticed and thought about the 1996 coil bracket etc. earlier, I would have asked if you would take $10 and throw it in one of the two intake boxes. If that's reasonable, give me a shipped cost and se if you still have the air management valve(s) off the right side.
#59
Damn, wish I had noticed and thought about the 1996 coil bracket etc. earlier, I would have asked if you would take $10 and throw it in one of the two intake boxes. If that's reasonable, give me a shipped cost and se if you still have the air management valve(s) off the right side.