Category: Exterior - Body Parts
Price: $1
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): CRX & pre '92 Civic
Item Condition: CA
Shipping Information: Item can be shipped
Engine: Part suitable for gas truck, Part suitable for diesel truck

How about a drivers vent wing frame for a 51/52?
Thanks,Matt

 

Looking for running boards for my 52 F1, have any? If not, any leads. Thanks

 

Do you need the glass frame only or the assembly frame in which the glass frame sits in and pivots or the entire assembly with the glass frame?

Yes, I have a pair from a 52 F2.




Thanks for the pictures. I'll try to check tomorrow.

Do you need the glass frame only or the assembly frame in which the glass frame sits in and pivots or the entire assembly with the glass frame?

I sent you a PM reply.

Here's the pair I have currently.

 

Looking for front bed panel both inner fenders rear sections of both rear fenders( replacing a bad frenched taillight)
Also a glovebox door.
Scott

 

would you have an exhaust manifold for a '52 215 cu in ohv 6 cyl?

 

I found that brake part. Thanks for looking. Randy

 

Randy,

Sorry for not getting back to you fast enough. Good thing you found it because I couldn't locate it in my parts. Hopefully you'll try me again.

 

No on the front bed panel. I have inner fenders, but need to know the year of your truck as there were three designs: 48-50, 51, 52. All of these three group years had different design.

I have good rear fenders from 48-50.




I do not. It took me a while to find one for my 52 and the one I did find had cracks that needed repairs.

I do not of a yard here in CA that has many exhaust manifolds, but from 223s. The manifolds are the same except for the angled bottom (to the pipe) that started in 53 or 54. 52 manifolds had a straight bottom (to the pipe).

PM or email me if you need the info to the yard. I know he wants $125 for each manifold.

 

Any 48-50 F2-F3 Rear fenders?

 

I am restoring a 49 myself and need a better cab. I am going to advertise my existing cab that is repairable, but I would like to find one that still has the remnants of paint left so not so much pitting. I am also going to advertise a frame, and I see that someone needs a tailgate. I have one that might work. For response please contact smillersc5@aol.com

 

I have a pair still attached to this truck. BTW, 48-52 F2/F3 rear fenders (and bed) are all the same.

 

PM sent about F2 rear fenders.

 

Greetings,

I am in need of the small spring that is attached to the hood opening lever.

Any luck??

Thanks

 

48-50 or 51-52?

 

Greetings. Thanks for your response. My truck is a 1950 F-1.