Wire Routing
Thread Starter
|
Senior User
Joined: May 2010
Posts: 407
Likes: 0
From: Southern IL
Wire Routing
What do you guy's do to route wire from the inside of the cab to the motor compartment. Do you drill a new hole and add a rubber gromet or pull the wire through an existing hole?
Lead Driver
Joined: Sep 2010
Posts: 7,793
Likes: 50
Depending on how many you need, theres 4 wires..blue, red, black and think yellow, right above your master cylinder. They run right under the dash to the right. laying dormant for this reason. Cool idea FORD did for us.
Senior User
Joined: Dec 2002
Posts: 277
Likes: 0
From: San Rafael, NM
This ain't hard
I ran 3 wires for an inverter system and HAM radios, all 4 awg in size, by simply heating up a screw driver to melt three holes through the rubber grommets that are located up and behind the brake pedal. Ford already cut the holes for you, so why do all the extra work.
If you do drill, be sure to use some sort of rubber or plastic grommet in the hole to pass the wires through or the wiring jacket will eventually cut through and short to ground.
If you do drill, be sure to use some sort of rubber or plastic grommet in the hole to pass the wires through or the wiring jacket will eventually cut through and short to ground.
Thread
Thread Starter
Forum
Replies
Last Post
ricepaddydaddy
Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics
2
May 17, 2004 06:19 PM
Brently
Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics
8
Jan 22, 2004 03:35 PM
Pass The Peas
Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics
3
Sep 28, 2003 12:06 PM
