Quality set of new tools on the market
#33
Well, I got to use them today!
Son-In-Law came over to do the front brakes on the Mustang he bought from my son. Saw him griping about and struggling with a 12mm bolt on the caliper. So I asked him if it was too tight or just in a bad position, as he made a mighty pull on that short metric box end wrench, and let out a grunt worthy of a two day poop he'd been holding in (sorry for the graphics, just gotta let ya know how hard he was pulling, LOL!) he answered and said the bolts were on very, VERY tight.
So I smiled and handed him the leveragewrench and told him to try it on the next bolt.
He said no, he's got it and he'd be fine.
Well, after a short struggle, he asked for the wrench and stated, "Oh daaang" as the bolt broke loose with a lot less strength.
He say's I always have the coolest tools.
That I do!
Thanks again!
Stewart
Son-In-Law came over to do the front brakes on the Mustang he bought from my son. Saw him griping about and struggling with a 12mm bolt on the caliper. So I asked him if it was too tight or just in a bad position, as he made a mighty pull on that short metric box end wrench, and let out a grunt worthy of a two day poop he'd been holding in (sorry for the graphics, just gotta let ya know how hard he was pulling, LOL!) he answered and said the bolts were on very, VERY tight.
So I smiled and handed him the leveragewrench and told him to try it on the next bolt.
He said no, he's got it and he'd be fine.
Well, after a short struggle, he asked for the wrench and stated, "Oh daaang" as the bolt broke loose with a lot less strength.
He say's I always have the coolest tools.
That I do!
Thanks again!
Stewart
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Vendor Specials, Discounts, Product Announcements & Group Buys
0
03-11-2019 01:38 PM
pilot10
General NON-Automotive Conversation
19
10-29-2001 10:33 PM