boss9f100 Projects page
#286
#287
#288
#289
#290
#291
#294
#296
Thanks All!
Its been a touch one but finally making progress.
Another reason the core support has to be in exact location is so I could use the '11-14 remote hood latch.
Turns out I just needed to make a loop to fit the latch and it aligns perfectly.
I will of course have to make a cover of sorts so it cannot be tampered with.
Video so not sure if it will imbed or not.
Its been a touch one but finally making progress.
Another reason the core support has to be in exact location is so I could use the '11-14 remote hood latch.
Turns out I just needed to make a loop to fit the latch and it aligns perfectly.
I will of course have to make a cover of sorts so it cannot be tampered with.
Video so not sure if it will imbed or not.
#297
#298
I was hoping to use the inner structure from the '11 but angles area all wrong. mostly because I dropped the cab so much over the chassis.
Test fit on front clip. in pic the I/C is in stock '11 position. That is why I ended up starting from scratch just building one.
Also note the computer is in stock '11 location in cowl area. Another chore to get it to fit yet have the HVAC fit too.
Test fit on front clip. in pic the I/C is in stock '11 position. That is why I ended up starting from scratch just building one.
Also note the computer is in stock '11 location in cowl area. Another chore to get it to fit yet have the HVAC fit too.
#299