Heads are off 1 piston dinged up top???
#1
Heads are off 1 piston dinged up top???
Well I was just going to pull the HPOP off the spare motor for my T500 core. When I stopped the engine was on the stand and the heads where in the floor. Cylinders dont look bad at all, but the top of one piston looks kinda hammered up. This is my first time into a diesel motor so kinda learning as I go. I have seen dinged up pistons on my Banshee but it is always pretty obvious what causes it and the cylinder usually gets tore up a little.
On here the cylinder does not look bad and not sure what would cause it. Not sure of the number of the cylinder but it would be the passenger side closest to the firewall.
On here the cylinder does not look bad and not sure what would cause it. Not sure of the number of the cylinder but it would be the passenger side closest to the firewall.
#3
Thread
Thread Starter
Forum
Replies
Last Post
pineconeford
1948 - 1956 F1, F100 & Larger F-Series Trucks
19
04-19-2016 07:33 AM
Moore558
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
6
11-30-2007 07:04 PM