Hi all,
One of my trucks is a stripper work truck meaning no power anything, the mirrors on it currently manually telescope but are easily knocked out of adjustment, is it possible to install power mirrors on a truck that did not have them originally, is the harness in the doors for such a conversion? I would like to have just the basic power mirrors that manually telescope. Any information would be greatly appreciated.

Dan

 

No harness. You will have to get the switch and trim piece for the driver door. then you have 1 of 2 choices- buy the wire harness from the dealer for big $$$$, or run your own.

Did this on old green, as it did not have power mirrors. The schematic for switch is on the site. It's really not that bad of a job.

 

Thanks for the reply, not sure if its worth it.

Dan

 

Yes, it is. It always sucked needing someone else's help just to adjust the passenger mirror. The wire, switch and trim won't cost much.

 

I agree with you on that, I will look into it further.

Dan

 

Where is switch schematic? I have mirrors and switch sitting in shop, just havent figured it out yet.