Category: Accessories
Price: $300
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): NSX
Item Condition: NC
Shipping Information: Item can be shipped
Engine: Part suitable for diesel truck

I have 5 ISSPRO gauges Pyro, Trans, Boost, Oil Temp, and Oil Pressure for sale plus one 3 gauge over head pod and one 3 gauge under dash pod. I used the Pyro, Trans, and Boost in the overhead pod. When I installed them I trimmed the tabs on the pod a bit too much and had some trouble keeping it mounted properly, I also cut the slit down the back to fit over rear view wires....it yours to fool with ....I purchased the Oil Temp/Pressure gauges from a guy who never installed them....I never did either...went with an Edge CTS Insight. If you are familiar with gauges they came with mounting "brackets" on the back I cut the bolts off to ease mounting and went with wraps of electrical tape to keep the gauges in the pod. The pyro probe is good, you will need to buy a new collet and manifold part as it is galled. The black bezel on the gauges show some wear but function. Trans and Pyro have the extension cables, boost has about 10+ feet of tubing..you will need to get the fitting that goes on your elbow. The pods are both painted tan (Med Pebble or Parchment...I forget), the Pyro, Boost, and Trans have had the bulbs replaced w/LED's. The trans temp probe is still in my trans, I have to get a replacement plug tomorrow. $300 plus the ride from 28376 gets them.

 

Still available?

 

Yep...your the first to respond

 

Looks like you had some one respond. Are the gauges still available? Do you know if the collet and manifold parts are sold separate? Are these isspro ev or ev2?

 

Yes they are still available....believe they are the ev vs. ev2, I think the ev2's have all of the electronics in the actual gauge, whereas these have the boxes seen in the top of the photo of everything. Yes you should be able to buy the collet/manifold part separately, I originally bought this stuff from Diesel Manor they also sell the tap for the manifold and paint to match pods.

 

Thanks for the info. After a little
Research I decided to go a different direction. Thanks again.

 

Still have them...any takers???

 

still available? live in 28025 zip code email bottom dollar plus shipping. hvacmaniac92@yahoo.com

 

So was it the pillar mount that you shaved down too much or was it the under dash pod? I may be interested in the under dash pod.

 

Sold pending receipt of money