Aligning transmission splines to clutch plate??
#1
Aligning transmission splines to clutch plate??
Hi,
I am in the process of upgrading my stock clutch to a southbend and getting ready to lift the transmission up to the reconnect to the engine. However, it was a real bitch to get in pulled back and off the engine. Now, I am thinking how the heck am I going to get the splines from the input shaft to line up with the splines in the clutch plate without damaging anything?
Any tips, help?
Thanks,
Terry.
I am in the process of upgrading my stock clutch to a southbend and getting ready to lift the transmission up to the reconnect to the engine. However, it was a real bitch to get in pulled back and off the engine. Now, I am thinking how the heck am I going to get the splines from the input shaft to line up with the splines in the clutch plate without damaging anything?
Any tips, help?
Thanks,
Terry.
Thread
Thread Starter
Forum
Replies
Last Post
Eallend7
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
34
01-28-2013 04:54 AM
Bennyteee
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
6
12-06-2004 03:08 PM
Zoomie331r
Clutch, Transmission, Differential, Axle & Transfer Case
3
09-24-2004 08:50 AM