Specs needed
Thread Starter
|
Senior User
Joined: Mar 2002
Posts: 288
Likes: 0
From: Farmington MN U. S. A.
Specs needed
Ok guys my parts come in tomorrow and its finaly time to put this 390 together!!!! I am short however of an accurate spec book so I was wondering if anyone out there has the specs I need for the entire rebuild? Im talking the rods, mains, I even need the bearing clearances (for plastigauge). I also need any pointers or sugestions you guys have for me...
Thanks for the help! I know the people here will do more than just come through.
Thanks for the help! I know the people here will do more than just come through.
Senior User
Joined: Jan 2003
Posts: 451
Likes: 0
From: Balfour
Specs needed
Buying a manual yourself would be a better idea as there is 4 pages covering clearences etc. in my ford shop manual, and alota stuff about how it goes together.
The national hot rod association's site has a good pile of spec's.
I'm bored not having to work at all, but not that bored
The national hot rod association's site has a good pile of spec's.
I'm bored not having to work at all, but not that bored
Senior User
Joined: Aug 2002
Posts: 327
Likes: 1
From: Belleville USA
Specs needed
Get the book called, "How to Rebuild Big Block Fords" by Steve Christ. I bought it just for general knowledge but feel very confident that if I wanted to rebuild a 390, I would have no problem.
Thread
Thread Starter
Forum
Replies
Last Post
ereck01
1973 - 1979 F-100 & Larger F-Series Trucks
13
Feb 15, 2013 05:16 PM
factorystock
Clutch, Transmission, Differential, Axle & Transfer Case
7
Jun 27, 2002 02:38 PM
