When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey everyone, I'm swapping out my blown V10 in my 99 SD and putting in a lower milage mill, starting Monday. I'm in Marlborough and have all tools, engine hoist, lotsa jack stands, etc.......unfortunately truck doesn't fit in garage, too high.
Any volunteers to help? I'm pulling old engine hopefully on Monday and new one is arriving in afternoon. Probabely wont be able to get new one in until next Monday unless I have help.
I'd love to but by the time I got there it'd probably be getting close to dark. Maybe 2:30ish by the time I got there.
Got a street address? I'll try to make it at least. Not sure I'll be tons of help since I don't know a darn thing about those sparkplug fired contraptions but I'll try.
Thanks you SO much Brendon and Pete, you guys were a huge help today in the couple of hours we could stand the cold. I wouldn't have half as much done without you.
I will get the new one on the stand this week and try to get the things bolted on that we need. Hopefully it will be Monday I have the same time slot in the afternoon to get it done.
Okay so tomorrow, 2pm on......still in guys? I'll have the pizza come at like 3? Whatta ya like? Engine is up on stand, I should have the bolt accessories on before then. Today is all about snow removal from around truck, lol.