Please do not repost, forward or otherwise publish messages
contained in these archives without consent from the respective
author(s). These archives may not, in whole or part, be stored on
any public retrieval system (FTP, web, gopher, newsgroup, etc.) by
individuals or companies, without consent of the respective authors.

Received: with LISTAR (v0.128a; list perf-list); Sun, 25 Jun 2000 14:14:08 -0400 (EDT)
Date: Sun, 25 Jun 2000 14:14:08 -0400 (EDT)
From: Ford Truck Enthusiasts List Server ford-trucks.com>
To: perf-list digest users ford-trucks.com>
Reply-to: perf-listford-trucks.com
Subject: perf-list Digest V2000 #87
Precedence: bulk

==========================================================
Ford Truck Enthusiasts Performance, Hot-Rod and Custom
Truck Mailing List

Visit our web site: http://www.ford-trucks.com

To unsubscribe, send email to: listarford-trucks.com with
the words "unsubscribe perf-list" in the subject of the
message.
==========================================================

------------------------------------
perf-list Digest Sat, 24 Jun 2000 Volume: 2000 Issue: 087

In This Issue:
Re: Clutch problem
T-18 problem

----------------------------------------------------------------------

From: JUMPINFORDaol.com
Date: Sat, 24 Jun 2000 14:18:02 EDT
Subject: Re: Clutch problem

Have you tried rotaing the flywheel on the crank? All Fords Ive seen have it
so it will only bolt on one way, set it on the flange, and start rotating
it. Should line up somewhere.

Darrell & Tweety

------------------------------

From: "Joel Thomas" prodigy.net>
Subject: T-18 problem
Date: Sun, 25 Jun 2000 14:16:07 -0500


I have a 1984 F-150 with a 351W and T-18 4sp granny low manual tranny(4wd)np208 trans case.

the problem is usually when putting into reverse you had to push it over with some force and then down because there was a spring in there it felt like.
but something happened to it yesterday and now it will just flop over with no force then you put it into reverse. its not a problem except when you put it into 3rd gear it is hard to find it because there is not spring to hold the shifter from flopping over into the reverse gate.

here is that pattern.


1 3

2 4 R T-18 granny low.

can i please get some help and a fix so that i can fix this.?

thanks
Joel Thomas



------------------------------

End of perf-list Digest V2000 #87
*********************************
----------------------------------------------------------
Ford Truck Enthusiasts Performance, Hot-Rod and Custom
Truck List

Send posts to perf-listford-trucks.com

If you ever want to remove yourself from this mailing
list, send an email to:

listarford-trucks.com

with the words "unsubscribe perf-list" in the subject of
the message.

Visit Our Web Site: http://www.ford-trucks.com
----------------------------------------------------------

ENDTAG; } ?>