| Photos in this album |
Click for full size image
What I'm starting with, not bad for $100. The retro hoodscoop is ...
| 
Click for full size image
We cut the fenders out big enough that I used my 38.5 as a templ ...
| 
Click for full size image
There is some work to be done, but nothing a welder can't fix ...
| 
Click for full size image
The truck was rolled and hit this corner, causing the rest of th ...
|
Click for full size image
2x4 box tubing, braced with 2" angle to use as a tow/recovery po ...
| 
Click for full size image
That hook is a 1" diameter solid steel hook! plus we added the 2 ...
| 
Click for full size image
We did the same to the front, using the 2x4 box tube and 15k "D" ...
| 
Click for full size image
I know it's overkill for a tie down point, but hey, you never kn ...
|
Click for full size image
With the frame needing some sort of stand, we used some old kegs ...
| 
Click for full size image
When we pulled the motor apart, it was clean on the inside. ...
| 
Click for full size image
Not sure why, but all of the valves were really white, on both h ...
| 
Click for full size image
This is one of the dished pistons. The cylinders were so clean, ...
|
Click for full size image
...
| 
Click for full size image
I don't have the coilovers in the rear yet, I just wanted to get ...
| 
Click for full size image
...
| 
Click for full size image
...
|
Click for full size image
...
| 
Click for full size image
...
| 
Click for full size image
...
| 
Click for full size image
...
|
Click for full size image
...
| 
Click for full size image
...
| 
Click for full size image
...
|
|
|
