Technical Service Bulletins
|Publication Date: MARCH 2, 1998|
|1997 F-250 HD, F-350|
This TSB article is being republished in its entirety to correct the “New Calibrations” listed in the PCM Calibration Reference Chart.
|WARNING:||THIS MODIFICATION IS AUTHORIZED ONLY FOR THE LISTED ENGINE. PERFORMING THIS MODIFICATION ON OTHER ENGINE CALIBRATIONS IS UNAUTHORIZED AND COULD CREATE LIABILITY UNDER APPLICABLE FEDERAL OR LOCAL LAWS.|
An engine stall condition may occur on some 1997 California F-Series 7.3L Diesel E4OD vehicles after a long decel when using M1 gear for engine braking. When upshifting after the decel, the engine may stall if it is at approximately 1000 rpms (10 mph). This may be caused by the Powertrain Control Module (PCM) calibration.
Reprogram the PCM. The revised calibration modifies the fuel control governor to reduce the possibility of stall. Refer to the following Service Procedure for details.
- Perform normal diagnostics as outlined in the 1997 Powertrain Control/Emissions Diagnosis (PC/ED) On-Board Diagnostics II (OBD-II) Service Manual and service as required.
- If the concern still exists, reprogram the PCM using the latest level CD-ROM and Service Bay Diagnostic System (SBDS) or New Generation Star (NGS) Tester. Refer to the following PCM Calibration Reference Chart for the correct calibration.
PCM CALIBRATION REFERENCE Old Calibration Old Part Number (-12A650-) New Calibration New Part Number (-12A650-) 7-90P-R10/11 F7TZ-RD/RE 7-90P-R12 F7TZ-RF NOTE: PCM REPLACEMENT IS NOT AUTHORIZED BY THIS TSB. REFER TO THE POWERTRAIN CONTROL/EMISSIONS DIAGNOSIS (PC/ED) SERVICE MANUAL FOR APPROPRIATE DIAGNOSTIC PROCEDURES IF PCM HARDWARE CONCERNS EXIST.
Obtain an Authorized Modifications Decal (FPS 8262 – obtainable through DOES II, 25/pkg) and list the date, dealer number, and summary of modifications performed. Select a prominent place adjacent to the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it with a clear plastic decal shield.
OTHER APPLICABLE ARTICLES:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
|980414A||Reprogram Powertrain Control Module (PCM)||0.2 Hr.|
|BASIC PART NO.||CONDITION CODE|
Copyright © 1998 Ford Motor Company